Zone Fly Industrial and Trade Co., Ltd.

Circular Saw blade Safety

The tungsten carbide tipped circular  saw blades are designed for many special applications and can be used to cut a variety of materials. They are manufactured with finest tungsten carbide tips and different tooth design for special use. All carbide tipped blades can be re-sharpened or re-tipped for longer sawing life.

Operating Conditions

█  Machine cover is essential to minimize the injuries by flying broken blades.

█ Irrelevant people are not allowed in the work shop.

█ Flammables and explosives should be kept away from the work floor.

Safety Measures

█ Wear glasses when working, to prevent from injuries by broken blades.

█ Watch out for your ties and sleeves. Long hair should be kept inside the cap, and no gloves are allowed during operation.

Before Use

█ Ensure the machines are in good condition with no deformation and no spindle vibration, the spindle's running tolerance can h7.

█ Make sure the blades are not excessively worn-out, blade body has no deformation or breaks lest injuries occur.

█ Make sure appropriate saw blades are used.

Installation

█ Ensure the saw blade turns in the same direction as the spindle does. If not, accidents are likely to occur.

█ Choose the flange whose inner diameter is the same as that  of the saw blade but the outer diameter is a little larger than 1/3 (for multi-rip saw blade is 1/2) of the saw blade. Ensure the flange is clean, not over worn, bent and distorted shape.

█ Check the tolerance between the saw blade and the spindle. Install the flange and fasten the screw.

█ Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is a vibration, radial or axial run out.

█ Saw blade reprocessing such as bore trimming or re-boring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries.

█ While installation, the saw blade should be 5-6 teeth higher than the board surface.

In Use

█ In operation wood materials should be properly fixed lest abnormal cutting occurs.

█ The operation must be stopped rightly once unusual nose and vibration occurs, if not, rough surface and tip-breaking many occur.

After Use

█ Saw blade should be re-sharpened because dull saw blades many affect cutting effect and lead to accidents.

█ Re-sharpening should be made by professional factories, not changing the original teeth angle degrees.